Sunday, September 18, 2011

marking runways

I have found that the easiest way to find your runways is to mark them with the usual yellow (or blue) pushpin, but in the properties section I choose the altitude as 100 metres, relative to the ground, and extended to ground.

This way, when you are flying in for a landing the yellow pin is up in the air on a yellow column, where you can see it as you line up for a landing.
at

4 comments:

  1. AnonymousSeptember 29, 2011 at 5:17 PM

    I,m also marking my runways with yellow pins but I'm always using 2 pins on the beginning and the end of runway with number of the runway in it and one of pins has added airport name and code. f.ex. 07 Sion (SIR) and 29. You can also turn on the airports layer in the Transportation bookmark.

    ReplyDelete
  2. Alan FlightSimSeptember 30, 2011 at 8:02 AM

    Thanks for note. I picked up the suggestion of using the yellow pin on a tall column from an earlier comment years ago when Flight Simulator first appeared. I have used pins at both ends of the runway, especially on strips where I land from both ends.

    I like the idea of marking the pins with the airport name and runway number. I will also try the Transportation layer.

    Thanks . . . Alan

    ReplyDelete
  3. AnonymousJanuary 25, 2014 at 12:05 PM

    Hi...I have made a code quite similar to yours but I can't figure out how to apply it to the simulator so it will change the controls.
    Thanks,

    ReplyDelete
  4. odedanaegeleMarch 4, 2022 at 1:53 AM

    How to Win at the Casino - DRMCD
    The most simple 안동 출장샵 and 목포 출장마사지 easy way to win at the 문경 출장마사지 casino is by earning points 평택 출장마사지 and playing as you win. This is when your 광명 출장안마 luck begins to pick up

    ReplyDelete